SXK Narda leaking?

[RunTheJewels]

Hey apes

Great flavoursome Atty but I have a problem with liquid steeping out when I put the top cap on. Anyone have this problem and is it something I have to live with.

I changed both o rings at the bottom due to the originals being so good damn thick that was a chore putting the top cap back on

 

[Moley]

Had nothing like that, I let Mrs Moley have a go and she over squonked and a tiny amount came out an airhole but nowt from the top.
Then again I don't take the top cap off, I presume you're using it as a straight dripper?

 

[RunTheJewels]

Had nothing like that, I let Mrs Moley have a go and she over squonked and a tiny amount came out an airhole but nowt from the top.
Then again I don't take the top cap off, I presume you're using it as a straight dripper?

Indeed I am. The juice is steeping out the bottom. I don't know what's going on! Looks like it's juice traveling slowly out , it's not flowing out but it's coming out very slowly

 

[Simon G]

Change the o-rings back, it's tight for a reason, if liquid is getting past two o-rings then clearly the o-rings aren't doing their job as a seal.

 

[RunTheJewels]

Change the o-rings back, it's tight for a reason, if liquid is getting past two o-rings then clearly the o-rings aren't doing their job as a seal.

The problem being.... Wismec shitty 510. I have a noisy cricket 2 and screwing down the Narda, I feel it's pushing it, then on top I'm forcing the top cap back on (with original o rings)

 

[Simon G]

The problem being.... Wismec shitty 510. I have a noisy cricket 2 and screwing down the Narda, I feel it's pushing it, then on top I'm forcing the top cap back on (with original o rings)

I hear ya .... maybe one of the thicker ones and one of the thinner ones?

 

[RunTheJewels]

I hear ya .... maybe one of the thicker ones and one of the thinner ones?

That's an idea. Will try later when im back home. Will update later

 

[Simon G]

That's an idea. Will try later when im back home. Will update later

I've done it before ..... on the mad hatter mini if I recall, I put the fatter one at the bottom and put a thinner one on top, then you only have to push it past one thick ring and any juice that gets past the thinner one should be stopped by the thicker one underneath.

It's a bit of a compromise but it worked ok.

 

[RunTheJewels]

No luck. Think I'll put them up for sale of trade In abit. :-(

 

[eyeball kid]

No luck. Think I'll put them up for sale of trade In abit. :-(

Sounds ridiculous but it didnt come with the squonk pin installed did it.