Tester wanted for: SERIES B DNA 75 (new sandstorm 25mm version)

[Coolie27]

Hi all, it’s been a while. My Mod all of a sudden last night stated too hot.
It’s only ever been used in Wattage mode. Cycled through and ensured TC was turned off. Changed battery, left battery off overnight. Still states too hot. Anyone experienced the same or have any further advice. Cheers in advance.

 

[Michael jackson]

You using a tank or rda

 

[Coolie27]

I had been using the berserker MTL then changed to Zenith.

 

[Michael jackson]

Have you tried linking to escribe and re installing settings

 

[nwhornet]

Check with Escribe & see what the board temp is. If the board temp is too high this can cause the error. Possible it's a temp sensor on the board has failed.
@JAC Vapour

 

[Coolie27]

No, do you think that would work? It’s worth a try. Do I just download the programme from escribe website? Cheers

 

[Coolie27]

Check with Escribe & see what the board temp is. If the board temp is too high this can cause the error. Possible it's a temp sensor on the board has failed.
@JAC Vapour

Cheers I’ll check it out.

 

[Michael jackson]

Yes mate just download it from there

 

[Coolie27]

Yes mate just download it from there

I’ll give it a go. Cheers.

 

[nwhornet]

https://www.evolvapor.com/products/dna250 download the International version & ignore the 250 bit. It's all the same. Once installed, connect the mod via usb & go to device monitor. Ensure the board & room temp check boxes are ticked. You'll see the board & ambient temp showing.