Hi all vapes. Again coming to you with question. Well i have a problem my tsunami is leaking where the 510 pin is even when its with non squanker pin so i tighten rda to my mod but when tightened air holes are not on the sides of mod but like diagonal! Tried many times to unscrew rda and change position and screw it back not a change so any solution because from air holes there is condensation on mod. I hope you will understand my writing. I will upload picture! Thanks to all you guys.
Tsunami 24 plus rda air holes adjustment.
- Thread starter Hopipola
- Start date
I lile the idea but i dont know where my rda is leaking from and im afraid it might be from pin hole but not sure thought...what im trying to write is if there will not be close contact between rda 510 to mod it might leak... Well might give it a try...i guess just plastic or rubber washer might help!?
mick brown
Veteran
- Joined
- Apr 30, 2016
- Messages
- 7,223
Are you sure it's not leaking from the air holes ?
If you over drip or have the cotton touching the air tube's inside then the juice will run down the tube's and out the air intake.
Just a thought.
If you over drip or have the cotton touching the air tube's inside then the juice will run down the tube's and out the air intake.
Just a thought.
Sometimes it is by my fault but then i normally unscrew atty and dry it out... And after some time when i don't over fill atty between atty and mod its wet (there is no gap its pretty tight) ! Changed one o ring the bottom one (it has two)
Similar threads
