johnmandy
Postman
- Joined
- Feb 8, 2014
- Messages
- 229
I'm sure this will have been posted on here somewhere, but please if you can help advise me on a few points.
I have pinched/borrowed this from another vaping forum.... but am a little stuck on a few points listed.
Here is the listed info:-
1....Insert the battery - it may flash three of four times, it may not. This is normal.
2....Hit the big button 5 or 6 times in quick succession, this will turn it on.
3....Press either one of the small buttons and keep it pressed until you see either NO1 or NO2. If it shows NO2 it is fine, it means it is in RMS mode which is what you want. There is a toggle action when you do this step, so if it is showing NO1, go through this process again and it will change to NO2.
4....I have found it better to go to Variable Wattage mode. If you press both small buttons at the same time for three or 4 seconds you will see a figure with either a small v or a small w after it. You want it to be set so it shows the figure with the small w after the number. This is also a toggle action. If it is showing a v after the number then go through this process again until you see a w.
5....Put your atomizer on top, do not overtighten, there is no need as long as it is reasonably secure it is fine.
6....To check the resistance of the atomizer press the right hand small button and keep it pressed for a few seconds and you will see the resistance value of the atomizer.
7....To check the remaining battery voltage, do the same thing with the left hand small button.
8....So you should now have 3.0W showing on the display when you press the small button on the right. A quick press of the right hand button will move the value up to .5w more than it was before. You maybe want to start off at about 7w.
9....A quick press of the right hand small button will move the wattage up by half a watt and a quick press of the left button will move the value down by half a watt.
Find your own personal sweet spot for vapor and flavour and you can leave it there. Whatever value of atomiser resistance you change it to, you should get pretty close to what you prefer in terms of vapor and flavour.
To switch it off, press the big button 5 or 6 times in quick succession. It will remember your settings after switching off and re starting it again
Now my question, and by the way I'm currently using my evod atomiser at 1.9 ohms, until I get my protank mini cleaned.
On point 4 above it states variable wattage mode, my vamo only states either power output or voltage output, I have no small v or w , forgive me for being simple, but which one is best.
I have pinched/borrowed this from another vaping forum.... but am a little stuck on a few points listed.
Here is the listed info:-
1....Insert the battery - it may flash three of four times, it may not. This is normal.
2....Hit the big button 5 or 6 times in quick succession, this will turn it on.
3....Press either one of the small buttons and keep it pressed until you see either NO1 or NO2. If it shows NO2 it is fine, it means it is in RMS mode which is what you want. There is a toggle action when you do this step, so if it is showing NO1, go through this process again and it will change to NO2.
4....I have found it better to go to Variable Wattage mode. If you press both small buttons at the same time for three or 4 seconds you will see a figure with either a small v or a small w after it. You want it to be set so it shows the figure with the small w after the number. This is also a toggle action. If it is showing a v after the number then go through this process again until you see a w.
5....Put your atomizer on top, do not overtighten, there is no need as long as it is reasonably secure it is fine.
6....To check the resistance of the atomizer press the right hand small button and keep it pressed for a few seconds and you will see the resistance value of the atomizer.
7....To check the remaining battery voltage, do the same thing with the left hand small button.
8....So you should now have 3.0W showing on the display when you press the small button on the right. A quick press of the right hand button will move the value up to .5w more than it was before. You maybe want to start off at about 7w.
9....A quick press of the right hand small button will move the wattage up by half a watt and a quick press of the left button will move the value down by half a watt.
Find your own personal sweet spot for vapor and flavour and you can leave it there. Whatever value of atomiser resistance you change it to, you should get pretty close to what you prefer in terms of vapor and flavour.
To switch it off, press the big button 5 or 6 times in quick succession. It will remember your settings after switching off and re starting it again
Now my question, and by the way I'm currently using my evod atomiser at 1.9 ohms, until I get my protank mini cleaned.
On point 4 above it states variable wattage mode, my vamo only states either power output or voltage output, I have no small v or w , forgive me for being simple, but which one is best.
Last edited:
