Want to get back into RBA's

[GROOF]

I'm getting a bit fed up of how often I'm changing heads on my nautilus now, so rather than try to rebuild these thought I'd get a kfl+ or russian or do it properly.

I did buy an original kfl+ when they first came out but it leaked a few times and I gave up pretty much before I had started and sold it on.

I'm after cheapest possible, so a clone. But where is the best place to get one from, and which is the easiest to use/ gives less problems. I don't mind a bit of a wait if it is from ft either.

Any links would be real handy

 

[Tubbyengineer]

I'm getting a bit fed up of how often I'm changing heads on my nautilus now, so rather than try to rebuild these thought I'd get a kfl+ or russian or do it properly.

I did buy an original kfl+ when they first came out but it leaked a few times and I gave up pretty much before I had started and sold it on.

I'm after cheapest possible, so a clone. But where is the best place to get one from, and which is the easiest to use/ gives less problems. I don't mind a bit of a wait if it is from ft either.

Any links would be real handy

For the combination of speed and a good clone go spend a few extra pounds with Vapegeek http://www.vapegeek.co.uk/Hcigar-Kayfun-31-78.htm, i've got a Kayfun 3.1 clone from them, works lovely (But change the airflow screw for a set screw from http://www.modelfixings.co.uk/cup_point_grub_screws.htm - i seem to remember they were M3x5

 

[GROOF]

For the combination of speed and a good clone go spend a few extra pounds with Vapegeek http://www.vapegeek.co.uk/Hcigar-Kayfun-31-78.htm, i've got a Kayfun 3.1 clone from them, works lovely (But change the airflow screw for a set screw from http://www.modelfixings.co.uk/cup_point_grub_screws.htm - i seem to remember they were M3x5

Thanks mate. I'll go have a look at those.