Which first drippers from FT?

[mrmattlaw]

Hi all,

I'm now an owner of a Vamo so am looking to buy a couple RDAs from FT. I've not yet built any coils but am a quick learner! I'm looking to get one dripper that's a fairly simple two post job and a three post one I can have a play with later on.

Which two would you recommend? I'm not too fussed on price and would rather buy something that produces real good vapour and taste rather than simply being n00b proof.

Thanks
Matt

 

[jimsie33]

I have bought an Igo-l from fasttech which is a good starter 2 post, although there are no holes in the posts so you have to wrap your wire round the screws and trap them. And for a 3 post dripper I got the V5 dripper which is a Nimbus clone. Produces plenty of vapour. I have changed the screws to phillips heads as the ones supplied are allen screws. Hope this helps

 

[mrmattlaw]

Ah thanks for the info, think I would prefer the posts to have holes in so I might look for a different two poster.

 

[5miley]

A very much under-rated dripper is the Immortalizer

http://www.fasttech.com/products/14...mmortalizer-rda-rebuildable-dripping-atomizer

More suitable for ribbon wire rather than normal Kanthal, gives great performance on par with any dual coil dripper

but its drawback is that it does not hold much juice

 

[Blackhack]

I've orderd both of these, they look like they will fit the bill for you too....


V5 Rebuildable Dripping Atomizer
http://www.fasttech.com/products/1632401


And


V7 Rebuildable Dripping Atomizer
http://www.fasttech.com/products/1632403

 

[ApOsTle51]

I got the fatty v3 clone and although the posts seem wide apart and really suited to microcoils, ive set mine up fine on a normal wrapped single coil.

ive tried a few drippers with side airholes and they never seem to perform as well as those which supply air from underneath directly below the coil. The A7 is a great 14mm dripper, fasttech only do the mini version which id imagine would perform much the same.

the fatty : https://www.fasttech.com/p/1573400

the A7/pheonix : https://www.fasttech.com/products/0/10006867/1608300-mini-a7-rebuildable-atomizer

both well worth it imo.

 

[Elemetrix]

Yup I have that V5 and quite like it. The little screws are pretty weak though. I'm going to replace mine tonight.

 

[mrmattlaw]

Ok thanks, will have a good sit down and read up on those.

 

[vaporsizer]

Igo w-4 is a good 3 pot dripper. Easy to build on, not a cloud chaser as it comes & is built well. I also got an Igo-T today & i'm finding that to be very good, possibly better again. Check out grey haze.
Obviously there's a lot more out there but it depends on what you want to spend.