Wrapping mesh in non mesh rda

[canada16]

I was thinking the other day about grabbing some long mesh, cut about
.5cm of mesh around a tool and see if I can use this instead of wire.
You think this may work in a non mesh rda?

 

[nwhornet]

I was thinking the other day about grabbing some long mesh, cut about
.5cm of mesh around a tool and see if I can use this instead of wire.
You think this may work in a non mesh rda?

How you going to clamp it. Mesh decks have dedicated clamps. Just by a Profile Unity or Kylin M.

 

[RichieRich]

As above. Unless there is a dedicated mesh clamp, you will get dry/burn hits and/or hotspots trying to use it in a coil clamp.

If you want to experiment with mesh RDA, try the Wotofo Profile.

 

[canada16]

No you cut lengthways into a long strip, you will then be left with 2 legs the size of your clamps.

Wrap around the jig like 4/5 times and then leave a bit at the end and you will be left with 2 legs.

Wait do they sell long spools of mesh you can cut about a few inches off?

 

[nwhornet]

No you cut lengthways into a long strip, you will then be left with 2 legs the size of your clamps.

Wrap around the jig like 4/5 times and then leave a bit at the end and you will be left with 2 legs.

Wait do they sell long spools of mesh you can cut about a few inches off?

Mesh on a spool is meant for decks like Profile, Unity, Kylin M etc. It's too fragile to wrap like wire, but please go ahead & take one for the team. [emoji23]

 

[rew]

I was thinking the other day about grabbing some long mesh, cut about
.5cm of mesh around a tool and see if I can use this instead of wire.
You think this may work in a non mesh rda?

You could always try a mesh wick.

 

[Bean0]

If it works in a Kayfun then I don't see why it won't work in an RDA...

 

[RAPTOREX]

No you cut lengthways into a long strip, you will then be left with 2 legs the size of your clamps.

Wrap around the jig like 4/5 times and then leave a bit at the end and you will be left with 2 legs.

Wait do they sell long spools of mesh you can cut about a few inches off?

I remember reading that, on Redit. Had had sorts of problems but got a setup that worked, in the end. Didn't he end up wrapping the mesh wound the wicking?

 

[canada16]

Yeah thats what I was thinking but would be a tad different in a RDA as I would need to create legs for the posts
I was not sure if the mesh would stay in place and go loose once you tried tightening on the posts.

Can you buy one long strip of mesh, I want to try it.

 

[oORobOo]

Yeah thats what I was thinking but would be a tad different in a RDA as I would need to create legs for the posts
I was not sure if the mesh would stay in place and go loose once you tried tightening on the posts.

Can you buy one long strip of mesh, I want to try it.

Vandy Vape do mesh spools, can pick it up on most decent online stores.

*Mesh really isn't fun when it goes wrong, I highly recommend filming your experience lol