What's new

Aga t2 first setup probs

Sometimes it's just a pain and others its easy. I use a 2.5mm drill bit and wrap my coil around it, then I roll my wick so it will just slide through the coil and trap the bottom wire off the coil under the negative screw. Then trap the top wire between the grub screws making sure it's not to tight. If its to tight that's what causes the hotspots. Takes a bit if practice but you'll soon get the hang of it :)
 
I had nightmares at first with mine and after loads of frustration I found the grub screw just wasn't holding the wire tight enough (credit to ZT for suggesting the grub screws are crap in the first place!). I then went on eBay and bought some ss 2.5mm nuts and that solved the worst of my problems. I have to use pliers to tighten them up fully but once done up they hold brilliantly :)

How do you do this, I presume you mean the negative post ?
 
Hi need some pointers please, just set up an Aga t2 for the first time, looked at all the videos onyYoutube and think I have done it right but one possible issue I have is the top wire where it connects to the centre post is glowing hot before all the other coils heat up , not sure if this is the norm or not also when cold the ohms are reading 2.4 but when hot it drops to 1.8 again not sure if this is normal or not? Poor quality video so you can see what is happening
http://m.youtube.com/watch?feature=plcp&v=zs7rgcTNKqk#

How to fix hotspots
http://wiki.planetofthevapes.co.uk/wiki/Fix_a_hot_spot_on_the_AGA-T
 
Back
Top Bottom