What's new

Anyone with a Kanger Subtank Mini? Help needed.

Have you checked whether it fires the stock coil? Or does the same problem happen with that?


Sent from my iPhone using Planet of the Vapes
 
Sorry, I was about as unclear as possible! I meant to have it together like in the original pic, 2 pics into the airhole, one slightly up, the other slightly down. Just to see if it was possible to actually see which of the two wasn't protruding enough. It looks like the lower one isn't as high as mine (the one coming down looks to be about right). Just hard to tell. If you put a disposable coil in, and it reaches down low enough, that'd suggest it's the underneath of the rba section not reaching down far enough. Sorry I'm not being much help.

What tobywonkanobi says - if it fires the stock coil it would seem the pin of the RDA is too short, if it won't fire either than it looks like the 510 isn't reaching up high enough


Sent from my iPhone using Planet of the Vapes
 
What @tobywonkanobi says - if it fires the stock coil it would seem the pin of the RDA is too short, if it won't fire either than it looks like the 510 isn't reaching up high enough


Sent from my iPhone using Planet of the Vapes

Stock coils fire no problem.

Thanks both for your help.
 
Can you take a picture from the bottom of the 510? I can compare to mine then and see whether it's protruding out further at the bottom which is why it's not reaching up top. ImageUploadedByPlanet of the Vapes1422387170.513884.jpg

Like this


Sent from my iPhone using Planet of the Vapes
 
Gonna eat shortly, can maybe pull it apart afters. my last comment I was saying that the pic made it look like one, but in my head it should be the other because the stock heads work. Bad photos but do these help?

ImageUploadedByPlanet of the Vapes1422387068.513897.jpgImageUploadedByPlanet of the Vapes1422387091.514265.jpgImageUploadedByPlanet of the Vapes1422387119.247579.jpg
 
Gonna eat shortly, can maybe pull it apart afters. my last comment I was saying that the pic made it look like one, but in my head it should be the other because the stock heads work. Bad photos but do these help?

View attachment 42228View attachment 42230View attachment 42231


The 510 in your last pic looks a lot longer in comparison to my photo.

Lol I'm baffled at where the issue lies. Thankfully my other half has one so I will take her RBA out and put it into mine tomorrow and see if I can narrow down the problem. Thanks again for the help. I will report back when I find the problem.

P.S. tobywonkanobi Don't worry about pulling yours apart mate. I will see how it goes tomorrow. Thanks :)
 
Last edited:
I had this first time I used the RBA section, check atomiser. I had to tighten the 510 up a bit so it made contact by putting a thin screwdriver through the two holes in 510 connector so I could turn and tighten it. I know this doesn't help as you say it's tightened as far as it will go but just thought I'd mention it in case you hadn't tried.
 
This has just happened to me I put some tweezers through the airflow gap in give it a little wiggle and it has moved slightly and now makes perfect connection you can also slightly unscrew the pin at the bottom of the RBA base which I realised after I fixed it :) hope this helps


Sent from my iPad using Planet of the Vapes
 
Back
Top Bottom