Atomizer short

[bear72]

All i saw was a firmware update for aegis legend 200 and 100 watts, nothing else

Ok don’t put that on it
Have you tried this in picture

 

[Spidereggsandoatmeals]

Ok don’t put that on it
Have you tried this in picture
View attachment 218200

Nothing happened it just displayed the version, and nothing more. The firmware version was v1.0 2017 1225. Do you think this is a firmware issue?

 

[Cozy]

Do you have another tank to try on it or could try someone else's tank? See if the same happens, you have clean 510 connection on both mod and tank, is the 510 connection adjustable, can you screw it in / out of tank? Do any of the threads of the 510 look damaged from what you can see

 

[Cozy]

Have a read through this too for the legend rather than the blade but the same checks apply

I'm guessing it's more a 510 connection issue, check the 510 on the mod, I think its spring loaded so should move then return, again try unscreeing the 510 to make it longer as may not be making contact properly

https://www.google.com/amp/s/guidet...ix-the-geekvape-no-coil-detected-warning/amp/

 

[LordOdin]

Try The Geekvape website.

 

[Spidereggsandoatmeals]

Have a read through this too for the legend rather than the blade but the same checks apply

I'm guessing it's more a 510 connection issue, check the 510 on the mod, I think its spring loaded so should move then return, again try unscreeing the 510 to make it longer as may not be making contact properly

https://www.google.com/amp/s/guidet...ix-the-geekvape-no-coil-detected-warning/amp/

Unfortunately, i don't have an extra atomizer YET. But as of today, its being prepared to be delivered tomorrow. For the unscrewing part, i tried that on the atomizer, but for the mod itself i haven't tried that yet. I'll give it a go. Thank you.

 

[Cozy]

Unfortunately, i don't have an extra atomizer YET. But as of today, its being prepared to be delivered tomorrow. For the unscrewing part, i tried that on the atomizer, but for the mod itself i haven't tried that yet. I'll give it a go. Thank you.

No you dont unscrew it just push a tooth pick or something small to see if the 510 in the mod moves, looking at this review it seems the 510 is spring loaded so it should move when pressed on then return to it's original position

https://www.ecigclick.co.uk/geekvape-blade-kit-review/

 

[nwhornet]

Could be a small piece of wire shorting out the 510. Either that or the spring has failed inside.

 

[bear72]

Nothing happened it just displayed the version, and nothing more. The firmware version was v1.0 2017 1225. Do you think this is a firmware issue?

I’m guessing you didn’t let go the up and down buttons
No software for it
If you use the aegis 200 watt software it will just brick it

 

[bear72]

I’m guessing you didn’t let go the up and down buttons
No software for it
If you use the aegis 200 watt software it will just brick it

What does the screen say with out a tank or rda on it