Building a Dripper with NI200

[sir_puffalot]

i have some 28G Ni200 wire on its way to me as we speak and i just want to run a few things past you apes with more experience.

i have run my build through steam engine and i plan on a 28G 0.16ohm 3mm 11 wrap single coil.

my questions are do i pinch or space the wraps, and do i wick it the same as a standard coil?

its going in my mutation X V4 with the bottom closed off (as i over drip when gaming )

 

[EmbraSewerRat]

From what I was told by the lovely @Tubbyengineer amoung other useful apses - space the coils and use a bit less cotton than you would in a Kanthal build.

And after than go look at the NiFe30 from the ever gorgeous @Stealhvape. Far better stuff than the Ni200. Damned sight more useable and so so much easier to build with!!

 

[Tubbyengineer]

From what I was told by the lovely @Tubbyengineer amoung other useful apses - space the coils and use a bit less cotton than you would in a Kanthal build.

And after than go look at the NiFe30 from the ever gorgeous @stealthvape Far better stuff than the Ni200. Damned sight more useable and so so much easier to build with!!

+1 for this, with the addition that you go look up the Nickel Microcoil Build Tutorial I did, quite a few folks found it of use...

 

[samcb18]

+1 for this, with the addition that you go look up the Nickel Microcoil Build Tutorial I did, quite a few folks found it of use...

Will the rdna40 fire NiFe30 wire?

 

[Tubbyengineer]

Will the rdna40 fire NiFe30 wire?

Yes, and at the 390f range the temps are pretty much exactlty the same so no need for offset at that temp, have a look at steam engine for the exact readings...

 

[samcb18]

Many thanks and will do!

 

[sir_puffalot]

kool thanks guys