What's new

Dripping on Mesh

@pogle

Just rolled mesh with a hollow centre.
Bear in mind that when you bend the mesh wick, make sure there are no kinks
Kinks in the mesh will impede wicking ability


Not tried SS rope in a dripper. I find SS rope to be a PITA .... cutting and preventing frayed bits sticking out

Just knocked a quick build of this,but only managed to get 3 or 4 hits before it needed a few more drips.So i dropped a wad of cotton underneath the wick to see if it would help...

IMG_0262.jpg

And despite knackering my coil getting the mesh through,its certainly chucking out the vapour...

IMG_0263.jpg

Although tbh i'm not sure if its just vapourizing the juice on the cotton where the coils touching it or from the mesh itself :hmm:
Does give a nice vape though...
 
Easiest method I've found for clean cable cutting is sharp chisel, big hammer, back of vice. One thump and cable screams "enough"

Sent by lazer from just north of the world's largest nuclear dustbin
 
Easiest method I've found for clean cable cutting is sharp chisel, big hammer, back of vice. One thump and cable screams "enough"

Sent by lazer from just north of the world's largest nuclear dustbin

this should do too.....
 

Attachments

  • mitre.jpg
    mitre.jpg
    31.1 KB · Views: 30
Just knocked a quick build of this,but only managed to get 3 or 4 hits before it needed a few more drips.So i dropped a wad of cotton underneath the wick to see if it would help...

View attachment 25968

And despite knackering my coil getting the mesh through,its certainly chucking out the vapour...

View attachment 25964

Although tbh i'm not sure if its just vapourizing the juice on the cotton where the coils touching it or from the mesh itself :hmm:
Does give a nice vape though...

Why not toss another coil on that second post and go to town on it?? You know, balls to the wall and such [; (from the mouth of the one who wants to smoke a steam engine just once [;
 
Back
Top Bottom