Fasttech Taifun GT 2 clone airflow

[charlieb]

Hi Guys , i recently received a GT 2 clone from fasttech , i cleaned it built it etc , but in my opinion the draw is too loose i have wrapped under all the apropriate orings with a thin strand of ptfe to make em tighter , so all seals are good and solid but anything past two air holes showing is exactly the same , am i missing something or is the gt 2 aimed at lung inhalers , as opposed to my mouth to lung?

 

[charlieb]

Sent from my iPhone using Planet of the Vapes

 

[HAZZA1962]

I have mine on Two Holes showing and it's fine!!! it's about the same as my V1 after I removed the centre Air tube!!!

 

[charlieb]

maybe i need to find a way to tighten the draw then , only a little , i wonder if i sleeve the air hole on the deck with something it might help mmm

 

[atomised]

I sometimes use a more restricted drip tip as I never seem to get the airflow right for mouth to lung just by using the airflow control.

 

[charlieb]

I just tried this to even out the effect of the airhole adjustment, can't see the point five holes if three do nothing it seems to have worked but won't be able to tell til I build it tomorrow good idea about the drip tip


Sent from my iPhone using Planet of the Vapes

 

[charlieb]

they should redesign these things with a max airflow adjustment screw and then use the airhole adjustment as a secondary fine tuning device

 

[atomised]

I'm sure you've seen it but this Taifun thread in ECF is good for a bit of bedtime reading. Although most people want to increase the airflow rather than decrease it!

 

[charlieb]

right tried out my experiment it worked well but i need to adjust the sleeve a tad to give a little more range at max air flow but it worked so i'm a happy ape

 

[monstermash]

wow mine's still in it's box as a quick dry test and i thought that's just too tight a draw on max airflow. Reckon you'd enjoy a GP Spheriod or Heron.