Help advice needed MVP and Dripping

[mozzer]

I know I cant sub ohm but I would to dry cotton wicks whats the device called with the wick going into a tank with wire going to screws.Also what size wire will be needed. Thanks

 

[sparkyjuice]

I think you mean a rebuildable tank atomiser ? AKA RBA ?

 

[jimsie33]

Do you mean something like the Aga-T? Never really had a lot of success with tanks and cotton wicks. As for wire something like 0.2 to 0.25. What is the lowest ohms the MVP will handle?

 

[Tubbyengineer]

Your best bet is to start with a Dripper, something like the Igo-w, Basically ats a holder for a wick & coil, and you drip E'liquid directly onto the wick a few drops at a time. Pabs ran a thread on building Microcoils for cotton wicks that you can use in a dripper...

 

[vaporsizer]

+1 for the dripper idea. An igo w or like is plain to see & to build into, make for a good intro to rebuildables & can be a keeper too. Not too pricey either.

 

[mozzer]

+1 for the dripper idea. An igo w or like is plain to see & to build into, make for a good intro to rebuildables & can be a keeper too. Not too pricey either.

Dont igo w have problems with air holes

 

[vaporsizer]

Dont igo w have problems with air holes

No. It's not problems, it's user preferences. Some people like to drill them out a bit bigger. I use an IGO T & it has the standard air holes. That gives me a kind of say, cigarette type draw & i'm happy with that. The w is probably a similar thing & they are intended that way.

On the upside, the option to drill is there, easier to take away than to put back. If you get one & find it too tight, drill it out starting small, perhaps 1.5mm & see where that takes you. Still too tight ? Try 2mm & so on.

 

[shakkadreadz]

Got my igo-w too tight for me I want it drilling a second hole.

Sent from my SM-N9005 using Planet of the Vapes mobile app