5miley
Achiever
- Joined
- Jun 23, 2013
- Messages
- 1,910
Just received a DIY self assembly Hana kit.
Everything seems straight forward, BUT .....
I am trying to figure out where to solder the negative wire on the 510 connector
Pictures speak a thousand words.
Here is the Hana box
The 510 connector
Here is the problem
Once the 510 connector is inserted into the hole, the bottom will sit flush with the box.
Only the positive centre pin will be exposed.
Now where is the negative wire suppose to go ?
I was thinking about stripping the anodizing from the hole and if you look at the first photo
see where I have marked "screw hole". I can see bare metal there, could I use that as the negative path ?
Everything seems straight forward, BUT .....
I am trying to figure out where to solder the negative wire on the 510 connector
Pictures speak a thousand words.
Here is the Hana box
The 510 connector
Here is the problem
Once the 510 connector is inserted into the hole, the bottom will sit flush with the box.
Only the positive centre pin will be exposed.
Now where is the negative wire suppose to go ?
I was thinking about stripping the anodizing from the hole and if you look at the first photo
see where I have marked "screw hole". I can see bare metal there, could I use that as the negative path ?