mm 510s are go

[hodge40]

for the builders the long awaited modmaker 510s are go on the site

http://www.modmaker.co.uk/MM510-Squonker-Connector

 

[gazlynn]

for the builders the long awaited modmaker 510s are go on the site

http://www.modmaker.co.uk/MM510-Squonker-Connector

thank you

cheers

Gaz

 

[paulbee]

I'm going to be building an Evic squonker eventually when I get round it, I've got a varitube 22mm. Does anyone know if this would be a better bet and whether it would fit?

 

[hodge40]

I'm going to be building an Evic squonker eventually when I get round it, I've got a varitube 22mm. Does anyone know if this would be a better bet and whether it would fit?

itll be pure speculation Paul - noone has one yet bud

 

[Pittard9]

Looking at these the top plate is 16mm diameter. Is there any reason for this? Most 3D boxes seem to have a 22mm diameter recess meaning these will leave a pretty big gap.

 

[hodge40]

Looking at these the top plate is 16mm diameter. Is there any reason for this? Most 3D boxes seem to have a 22mm diameter recess meaning these will leave a pretty big gap.

changable washers/plates for different sizes- or would be if theyd turned up[emoji23]

 

[Pittard9]

changable washers/plates for different sizes- or would be if theyd turned up[emoji23]

I assumed they were to go under the original toplate rather than to replace it. I must be missing something [emoji848]. Il have to have another look.

Edit: ignore me. I'm being an idiot and can't see the obvious. It does go under but I guess the recessed bit of the washer is 16mm so the original top plate sits inside it.

They look decent. Shame they don't have the 22mm Stainless washer in stock though.

 

[hodge40]

I assumed they were to go under the original toplate rather than to replace it. I must be missing something [emoji848]. Il have to have another look.

Edit: ignore me. I'm being an idiot and can't see the obvious. It does go under but I guess the recessed bit of the washer is 16mm so the original top plate sits inside it.

They look decent. Shame they don't have the 22mm Stainless washer in stock though.

think they were supposed to be but something was wrong with them mate

 

[Pittard9]

think they were supposed to be but something was wrong with them mate

Il hang on and as soon as they are in il stick an order in for both.

 

[jjde]

Got a couple, plus the 24mm washers. Can't wait to put them to use on a couple reuleaux dna200s I'm converting to squonkers.