Mod cup/ car cup holder mod.

[quick2bme]

This is a bell aluminum ashtray. It already work very well if you want a way to carry your mod broken down. But I can't find a car holder I like so I plan on modifying this one by adding a hole and maybe a gasket or so. Please fell free to give suggestions at will. Lets make this the best stand we can cause it should be an easy modification

 

[quick2bme]

Here is some pics of the bell cup holder.

 

[quick2bme]

Remove the top of the ashtray carefully. There is a small amount of glue in the front so carefully pry where the chrome meets the aluminum

 

[quick2bme]

 

[quick2bme]

Next I laid out my hole by using the bottom cap and a push pin as a center punch. And drilled a pilot hole. Then due to the material thinness softness ect I drilled a secondary hole just to keep the bit from grabbing and messing up the lid

 

[quick2bme]

 

[quick2bme]

Ok when I tried to post the last pics I had problems so I hope the final pics posts. But it has two holes that holds drip tips atomizer and it has room for my evic an extra battery and extra tank.. all I have left is a gasket to keep my evic from getting scratches. Hope you like it.

 

[quick2bme]

Final pics

Taking the checker flag and vaping the tires!

 

[vaporsizer]

Well, gotta like that really ! Well done man.

 

[quick2bme]

Well, gotta like that really ! Well done man.

Thank you! I really needed this cause I'm tired of reaching to the floorboards to get my evic.