What's new

My New Pocket Rocker Mod

RicModMaker

Vendor
Joined
Oct 29, 2013
Messages
3,240
Some say "It's not the size, it's what you do with it". I won't be commenting on that but I did fancy trying to build the smallest mod I could with an 18650 battery in it. The box I got was a plastic 75mm x 50mm x 25mm enclosure and I squeezed in a USB charger, a N mosfet circuit, a 16mm switch, Varitube 510 and an 18650 battery. Pretty happy with this one. It's far less bulky than I'm used to.

More photos here: Rics Pocket Rocker Mod V1

7.jpg
10.jpg
 
Last edited:
Ooh... looking good... wish I could make things like that! Really nice bit of kit.

Sent from my GT-I9505 using Planet of the Vapes mobile app
 
Nice one seedy! Is good to have a small form mod for when your on the run...bet your tempted to make another in wood :D

Insides are looking very neat using that pcb.

Did you bridge the connections with solder?

Only problem is i've seen various methods to use them, so im wondering which to learn first :P

I'm assuming its pcb you sell, i'm tempted to grab some to play with!
 
That's a tidy little MOD you've put together, a brilliant size for when you've not got a jacket or something with you.
 
That's done it, my next box is going to be plastic to accommodate the bigger lipo pack, cheers Ric

posted from a DIY juice cloud
 
Very nice seedy, I think you should call that the TARDIS! Not sure how you got an 18650 and contacts in there but my hat goes off to you!

How is that FET working for you?
 
Seedy on your V1 diagram you show the + from USB connected with center pin and switch ? Is that correct ? Surely that would fire the Atty if you connected a USB ? Or have I missed something.

Sent from my D2303 using Planet of the Vapes mobile app
 
Very nice Seedy. Is it strong plastic, could it take a night out with the lads?? Those boxes something you might be selling in the shop ??
 
Back
Top Bottom