New Innokin Zlide Kit

[Fuctifino]

Hi quick question, picked one of these up this weekend when it’s charged does the light turn green or amber to represent how charged it is mine seems to stay red while plugged in, then I take it off charge and it goes green or amber when I use it or turn it off which I’m guessing shows how charged it is truly ?

It will take QUITE A WHILE to fully recharge from dead
around 2:30hrs aprox from dead

GREEN is 60~100%
ORANGE 20~60%
RED is under 20% and will soon cut out
(pretty sure it cuts off at say 10% or something)

Turning it off (if charged) will blink 3 times
Turning it on again it will blink red, orange, green

As you fire the mod it will show a green light if 60% or above
The bottom blue selector light: left = above 1.0 Ohm, right = sub-ohm coil fitted
Or
Left blue = above Ohm & bars indicate 11, 12, 13 or 14w with all four bars filled
&
Right blue = Sub Ohm & bars indicate 14, 15, 16 or 17w with all four bars filled
(it's all on the underside with usb port)

As you fire the mod the battery will tell you then as you fire how charged it is
(Green = 60~100%, Orange 20~60% etc.....)

Most of the info is there, you just need to figure it out
Orange is about 40% charged give or take 15% either way

It takes a while to recharge - nearly 2:30hrs from flat
if it takes much longer you could be using a poor weak low charge usb lead
(the std lead is pretty decent to charge it in 2:30hrs)

If still taking longer to charge then the usb power supply is a low output say 0.5a
so trickle charges it, taking much longer to reach 100% fully charged

When charging I "think" it goes red, then orange, then green as it charges up
(then finally turns blank once it is fully charged (eventually))

hope some of this crap helps
as pointed out earlier in this thread the manual is bit messed up
the orange light goes from 20% to 40%
the green light goes from 60% to 100%
Ergh yeah what happens from 41% to 59% Innokin....