New small passthrough box mod.

[RicModMaker]

A bit of a squeeze but I finally got it all in and working.
The mod is pretty small at 90mm x 38mm x 30mm so I couldn't fit an 18650 in with all the stuff I've got in there.
It has a USB charger, DIY circuit board with slide switch, tactile switch with cap, N-channel mosfet, led and a couple of resistors and an 18500 battery.
2 time around and it actually works
I hope you like it.

Circuit board with mosfet, switches and resistors. Not pretty but it works.


Holes cut out.


Stuff crammed in. Not the prettiest job but it was a squeeze.


USB charger.


Flush 510.


Switched on and ready to go.


Plugged in and charging


Will I do one this small again? I'm not sure as it was a pain to get it all in there.
Onto the next one which should be a big daddy with more power than I need

 

[RicModMaker]

In action:

 

[Raguri]

Hammond case?

 

[Raguri]

And good job, no booms this time? Haha

 

[marcus-mulisha]

Nice tidy job mate!

 

[Chegs]

Well done mate,the whole idea is for your device to work.That it does so you should give yourself a well deserved pat on the back.

 

[doobedoobedo]

Very nicely done

 

[RicModMaker]

And good job, no booms this time? Haha

Surprisingly I didn't melt anything. Theres always next time when big daddy gets built. Its going to be large and powerful. I might die if it explodes but its all good! ;-)

Hammond case?

Yep.

Nice tidy job mate!

Thanks fella.

Well done mate,the whole idea is for your device to work.That it does so you should give yourself a well deserved pat on the back.

Mosfet does the job. Glad I got it working.

Very nicely done

Thanks fella.


Sent from somewhere just south on our nations capital.

 

[pez]

Nice one Seedy