Reuleaux RX200 and Limitless RDTA ramp up issues?

[johnnyknoxx]

I have my Reuleaux RX200 and on that I have a Limitless RDTA Plus with pre made Dual clapton coils that sets me at .11 ohms. I wish I could remember the gauge of the wire but I really can't but If I could guess it would be 22g.

However I see all over that many people say that 80-90 watts should give you a great warm vape at this resistance and I can't figure out why it is that I have to crank mine up to around 125 watts to even have good flavor and heat.

For example my friend has a Fuchai 200 watt with the same setup " Limitless/.9 ohm dual claptons " and he's telling me that all the wattage he has is 85 watts.

I just don't understand why it is that I have to crank mine up when everyone tells me that at 80 watts I should be fine.

 

[aj83]

I would be looking at your coil placement pal.

 

[conanthewarrior]

I would imagine if everything is in place correctly it is to do with the mass of your coils.

You don't mention what material your coils are made from(EDIT I am guessing Kanthal as you don't mention TC, my bad), if they have a very large surface area they will require a lot of power and have a slower ramp up than something smaller.

 

[wastedyears1981]

Coil Placement, knackered grub screws, loose posts, loose grub screws. The list could be endless as to why.

Try a rebuild, re crimp and re-wick ect. Make sure all posts are secure and not loose and the grub screws are nice and tight.

 

[andy3434]

I have my Reuleaux RX200 and on that I have a Limitless RDTA Plus with pre made Dual clapton coils that sets me at .11 ohms. I wish I could remember the gauge of the wire but I really can't but If I could guess it would be 22g.

However I see all over that many people say that 80-90 watts should give you a great warm vape at this resistance and I can't figure out why it is that I have to crank mine up to around 125 watts to even have good flavor and heat.

For example my friend has a Fuchai 200 watt with the same setup " Limitless/.9 ohm dual claptons " and he's telling me that all the wattage he has is 85 watts.

I just don't understand why it is that I have to crank mine up when everyone tells me that at 80 watts I should be fine.

0.9 ohm dual claptons and 0.11 dual claptons are not the same set up so won't vape the same at same power setting, also what some call a warm vape may not be what you call a warm vape. I would put some new coils in that you know the gauge of and use steamengine to make sure resistance is where it should be and take it from there, vape with what you are comfortable with not what somebody tells you to, your mod has plenty of protection built in to it so you are safe in that respect. If it is 22g wire it will need alot of power or have a long ramp up time.