Stoopid RX200

[vapenat]

Could anyone tell me the TCR for the RX200 for basic Titanium wire? Some sources tell me 306, some tell me 366, and neither feel very satisfying. Thanks for any help.

 

[dansus]

Keep raising TCR until it vapes right.

 

[vapenat]

Keep raising TCR until it vapes right.

I don't want to raise it too high and start getting dry hits; I like warm-hot vapes..

 

[Jugg1es]

Titanium is between 300-400, this would depend on the quality of wire though. Your 366 is more like where I'd start, what temps/watts are you aiming for?

 

[danb]

I was under the impression that most non-adjustable Ti modes use 350. You could always check the vendor's website for product information or email them.

 

[Jugg1es]

Time is 350 as standard but wismec rates it between 3-4 hundred in the manual. I've always used 350

 

[vapenat]

Titanium is between 300-400, this would depend on the quality of wire though. Your 366 is more like where I'd start, what temps/watts are you aiming for?

So far I've been using 40 watts on a 0.08 coil, around 450 F

 

[dansus]

So far I've been using 40 watts on a 0.08 coil, around 450 F

0.08?

You sure its titanium?

 

[vapenat]

0.08?

You sure its titanium?

Yeah, I only did six wraps, around a.. I think it was a 1.7mm precision driver. I'm only using a Derringer - No huge builds allowed.. So I thought. Just shoved a 3.2mm 24G 10 wrap in it. xD