quincey43
Achiever
- Joined
- Oct 23, 2014
- Messages
- 3,027
Great, thanks, think I will get the one from Provapes and the adapter if I need it.Ive read that the fastech SXK comes with a 3mm air hole, but mine from Provapes is 3.2 and they should fit.
Great, thanks, think I will get the one from Provapes and the adapter if I need it.Ive read that the fastech SXK comes with a 3mm air hole, but mine from Provapes is 3.2 and they should fit.
Just a bit of an update.
My kayfun 5 clone came today so I cleaned it and set about trying to make my first ever coil. I was aiming for between 1.2 and 1.8 ohm so did 8 wraps of 28 gauge kanthal wire round a 2.5 pin and my first attempt came out at 1.5 ohms. I guessed at the amount of cotton to use and gave it a try.
Well fuck me ! Spot on I was expecting at least half a dozen goes before I got it right so was well chuffed.
Thanks to @davrog for his advice.
@davrog I'm pretty happy so far. If I chain vape to much I get the odd dry hit so not sure whether that means I need to increase the wick size or just adjust it. I suppose a bit of playing with it is needed.
I read a review on the juice control and they recommended 1 1/2 turns for 50/50 mix and 2 turns for 70 vg. Does that sound about right ?Dry hits = too muck wick
Flooding / gurgling = not enough wick.
........but as the KayFun 5 has juice flow control, this may just need adjusting. You just twist the tank on it's base; anti-clockwise to increase juice flow, and clockwise to decrease it. Careful though, go too far anti-clockwise and the tank will come off!