Took the plunge!

[ZachSmiith]

Just took the plunge and ordered my first RDA,
The Fogger V3 from @ Vapegeek
First time with rebuildables but I think I am going to go with Cotton with Microcoils as these seem the most effective way to go.
Has anybody had any experience with the Fogger and Microcoils?

 

[BuffaloVapes]

Just took the plunge and ordered my first RDA,
The Fogger V3 from @ Vapegeek
First time with rebuildables but I think I am going to go with Cotton with Microcoils as these seem the most effective way to go.
Has anybody had any experience with the Fogger and Microcoils?

No, but I'm pretty sure you'll be a happy bunny!

Enjoy

 

[ZachSmiith]

Haha nice one - Hopefully I can figure it out!

 

[ill_dawg]

Remember: when you go to wick your coil, take the piece of cotton you thought you needed and cut it in half. 90% of the problems I had with cotton in the beginning were solved by using less of it. Too much will strangle the wick and give you dry hits. If you think it is too little cotton, it's usually just about right.

 

[robteifi]

You do have to be careful with the Foggers as if there's not enough cotton in the holes in the deck then it will flood. But you're not wrong about overstuffing the coil with cotton

First thing is to forget about the o-ring that sits on top of the wick when using cotton.

Once you've threaded the cotton through the coil, lay an extra, small piece of cotton on the wick in each of the slots on top of the existing cotton but not touching the coil. If you want to go a step further, put a little ball of cotton on the deck under each side of the wick to absorb any extra juice.
It is possible to do all this with a single long cotton wick by folding the wick back on itself and then tucking it under, easier to do if the wick is wet with juice. The important thing is not to block the airhole in the middle of the deck.

 

[modestvaper]

Also check out Todd's review. He mentions something about including an o ring to the 510 connection to make t safer I think.

Sent from my Nexus 5 using Planet of the Vapes mobile app

 

[robteifi]

Also check out Todd's review. He mentions something about including an o ring to the 510 connection to make t safer I think.

Very good point

 

[ZachSmiith]

Thanks for all the tips - Received today and took the pre-built coil off(Wasn't up too much)
Organic cotton balls don't arrive until tomorrow so took the initiative and used the cotton off a bud and used about half with a 6 wrap 30g kanthal microcoil and came out at 1.3 ohms! Exactly what I was aiming for - Working like a dream! Thanks all.

 

[allen]

Aaah! That's why I had to suck so hard my head nearly caved in.... my airhole was blocked. Damn obvious really.
I'll try again tomorrow.

Tried a few set ups so far and sadly not massively impressed.
I think maybe I just prefer gennys.

posted by phone using the incredibly well designed mobile app

 

[allen]

Recoiled today.
A vertical microcoil set up over the airhole (very easy using a blunt filling needle) with cotton around it.... much better

I still prefer my gennys though

posted by phone using the incredibly well designed mobile app