Vandy vape mesh strips

[Jd_]

No it's just sheet mesh on a roll. Depending on deck it could be length & width.
Mesh by it's very nature is a cooler vape than the equivalent resistance coil & there's no residual heat. I can run the Profile Unity as low as 45w but much lower & you'll start getting juice in the mouth as there's not enough heat to evaporate it. As for life of wicks, that'll depend a great deal on the juice & sweetners. I get a minimum of a week but average around 2 before rewicking & as long as you don't deform the mesh, a quick low power dry burn & rinse & it's good to go again.

With some .43 ss316L u think u would be able to get good vape out of the unity at like 25-30w?

 

[nwhornet]

With some .43 ss316L u think u would be able to get good vape out of the unity at like 25-30w?

Probably as you can reduce airflow. The Unity is on the restricted side of DL to start with. Given the OG Profile RDA runs around 20+w higher than the Unity, lower watts are always possible. Also as the mesh is SS you can use TC so would be much easier to run cooler.
Still not convinced you'll get 0.43ohm mesh coils out of them rolls though.

 

[ronnie.pearson]

These are a cheap alternative from slowtech. They're pretty good.