What to build on a Tsunami 24 & Serpent Mini 25.

[Pips Man]

Apes,
I have a RX2/3 and all I have laying around is some 26awg Kanthal so I know I need to order some wire.

With all these fancy coils along with the addition of SS, NI and TI I'm confused dot com.

I was thinking on some 22g SS but honestly I don't even know if that's a good choice.

HALP!

 

[Pips Man]

Daytime bump.

 

[chubbaduckie]

I use 24awg/26awg Ni80 mate 8 wraps round a 3mm bit. I used to use kanthal but i feel i get alot better flavour from ni80 which you can run in power mode and the ramp up is near enough none existent.
316SS ive got some 24awg which you can run in power mode or TC.
Ni200 Ti NiFe all to be run in TC which i dont use.
I think @Tubbyengineer has a thread on here with great TC advice. (Hope you dont mind the tag mate) [emoji38]

 

[EmbraSewerRat]

I use a fused Clapton in my Serpent Mini and that works just fine and dandy. Worth maybe buying a couple to try out in there.
You might want to try a parallel build in their the now with current supplies.

As for the Tsunami, well, 8 odd wraps of yir 0.4mm kanth should be useful. For now.

0.5mm 316L stainless steel could be amusing. But for sure 0.45 or 0.5 mm Nichrome is good. I use Mechs so Ni80 is my go to wire. The flattened Ni80 is peachy keen and awesome to use. Well worth buying from the delicate wee flower that is @stealthvape .

 

[chubbaduckie]

I use a fused Clapton in my Serpent Mini and that works just fine and dandy. Worth maybe buying a couple to try out in there.
You might want to try a parallel build in their the now with current supplies.

As for the Tsunami, well, 8 odd wraps of yir 0.4mm kanth should be useful. For now.

0.5mm 316L stainless steel could be amusing. But for sure 0.45 or 0.5 mm Nichrome is good. I use Mechs so Ni80 is my go to wire. The flattened Ni80 is peachy keen and awesome to use. Well worth buying from the delicate wee flower that is @stealthvape .

+1 for Ni80 Flat
+1000 for @stealthvape

 

[Tubbyengineer]

Apes,
I have a RX2/3 and all I have laying around is some 26awg Kanthal so I know I need to order some wire.

With all these fancy coils along with the addition of SS, NI and TI I'm confused dot com.

I was thinking on some 22g SS but honestly I don't even know if that's a good choice.

HALP!

I use 0.4mm SS316L or 0.4mm Ti01 for the bulk of my TC coils, with a little practice and the right wicking you should get excellent results especially with Kayfun 5's or Heron V2's - There are lots of other good atties but I'm particularly fond of those two as TC performance from them is faultless, and yes you should get good results on the Tsunami with either of those...

 

[Pips Man]

Thanks for the great info apes,
Just placed an order for 24awg or Ni80 and 22awg of SS.
Can't wait to start building [emoji106]