AGA-S advice

[head5000]

im hoping my first RBA, AGA-S, will be at hmoe when i get back.
Hoping for any advice, specifically about solutions to getting around leakage.

Im also going to start rebuilding T3S, ami crazy to think i would be able to coil not only the primary wick but also the 'flavor' wick?

 

[Raguri]

im hoping my first RBA, AGA-S, will be at hmoe when i get back.
Hoping for any advice, specifically about solutions to getting around leakage.

Im also going to start rebuilding T3S, ami crazy to think i would be able to coil not only the primary wick but also the 'flavor' wick?

Not crazy at all mate, to be honest, I use a single piece of 3mm silica to rewick

 

[head5000]

My vape mail arrived. Amazing. These things are really small. Had a duh moment when I tried to take it apart before removing the center post. Excited!

Sent from my GT-I9300 using Planet of the Vapes mobile app

 

[Chegs]

I too tried to take it apart before removing BOTH knurled nuts Never solved leaking as I just make sure it never lies on its side longer than a second or two. I also added a second air hole and it fair chufs out a cloud of tasty vapour now. If you use mesh wicks, careful rolling to leave a tube means you can run a dual coil setup that can be refilled without rebuilds using a syringe.

Sent by lazer from just north of the world's largest nuclear dustbin

 

[head5000]

Well, about ten attempts and a meter of kanthal later an ive finally got 2 functional coils.

The flavor improvement is great. I've been vaping RY4 on silica for about 2 weeks now and thought i just tasted too burnt with no/very little sweet caramel notes.
The caramel is much improved and i'm actually getting a nicotine high which i haven't got in about a month.