aqua build

[Phantom Diablo]

i know a few people have found the aqua a PITA to build so heres how i do mine.

0.28 mm Knathal, 6 wraps around a 1.2mm micro screwdriver

dual coils coming in at 0.6 ohms

cotton wick pulled through so its even both sides with 1cm tails.
give this a good coat of juice then using tweezers or similar tuck the tails into the channels as shown in the pic.

screw on the chamber all the way down. fill up to the threads then put the top cap 3/4 on. turn upside and then unscrew the chamber to reveal the airholes, this will stop any leakages then.
screw down top cap tightly pop on your drip tip and good to go.

 

[Miss Pepper]

i know a few people have found the aqua a PITA to build so heres how i do mine.

0.28 mm Knathal, 6 wraps around a 1.2mm micro screwdriver

dual coils coming in at 0.6 ohms

cotton wick pulled through so its even both sides with 1cm tails.
give this a good coat of juice then using tweezers or similar tuck the tails into the channels as shown in the pic.

screw on the chamber all the way down. fill up to the threads then put the top cap 3/4 on. turn upside and then unscrew the chamber to reveal the airholes, this will stop any leakages then.
screw down top cap tightly pop on your drip tip and good to go.

Cheers PD

Makes it look easy