Cleaning tube mod

[Zited]

It really depends on how much you use it and if there are other factors like juice spilling or if it was in dirty environment, outside etc...
Something like once one in 2 weeks. It only takes like couple of minutes so it's not a big deal and I do it when I feel like it. Also, like to dismantle the thing and dump it in soapy water for an half hour to soak. Then dry it and assemble again. Works nicely for those nasty spillages for example.

Well I'm just getting back into them as I ended up back on the cigs , takes me quite alot longer than a couple mins to polish and clean probaly cause I'm still new too it idk. It's always in my room I don't really bring my tubes outside never thought off lettjng it all sit in soapy water tbh I'm deffo gonna do that next time, can all the parts go into the water okay?

Thanks in advance for the help!

 

[Deleted member 54254]

As @oldhippydude said, you just need to clean the threads.

 

[Zited]

As @oldhippydude said, you just need to clean the threads.

Alright sweet thanks! Appreciate all the help the only thing that still concerns me and always makes me panic is that the tube does tend to always get hot since I have a habit of chain vaping I'm afraid of that causing

 

[Zited]

Also I'm sorry I know I must be so so annoying too u @John R the amount of times I've came too u for help is ridiculous I do seriously appreciate it

 

[Giurra]

About couple of minutes takes to disassemble mod, clean the threads and assemble it back. I didn't mean the polishing. Sorry if it was not clear. I saw cleaning the threads with brass brush from one of the Youtube reviewers and had one on hand that I bought for 3d printer.
Sure, you can dump disassembled mech mod in water. If it can withstand the e juice which is basically an alcohol chemically, it can withstand water. Just make sure to dry it thoroughly afterwards. I use regular tissue initially to remove the water then let it dry for an hour or so just in case.

 

[Deleted member 54254]

No need to panic, that's when mistakes happen, just be methodical about your builds and ensure the rda is a fixed protruding positive pin.

 

[Zited]

About couple of minutes takes to disassemble mod, clean the threads and assemble it back. I didn't mean the polishing. Sorry if it was not clear. I saw cleaning the threads with brass brush from one of the Youtube reviewers and had one on hand that I bought for 3d printer.
Sure, you can dump disassembled mech mod in water. If it can withstand the e juice which is basically an alcohol chemically, it can withstand water. Just make sure to dry it thoroughly afterwards. I use regular tissue initially to remove the water then let it dry for an hour or so just in case.

That's great, thank you for taking time out off your day too help a newbie like me out! I'll let u know how it goes next time I give it a clean too see if I notice a difference in how easy it is

 

[Zited]

No need to panic, that's when mistakes happen, just be methodical about your builds and ensure the rda is a fixed protruding positive pin.

Yeah I know I try not too. I normally go for 0.2ish type of builds with the drop dead and as far as I can tell the pin is protruding I find it quite hard to actually see cause my eyesight is pathetic hahaha but it looks like it is sticking out slightly if you would like me to post a picture I could try and do so

 

[Deleted member 54254]

If it makes you feel any better, sure.

 

[Zited]

If it makes you feel any better, sure.

Idk how clear that is too see... I hope it is protruding or I'm in trouble thanks again