D
Deleted member 54254
Guest
How the hell did you break an rda anyway?
Cleaning tube mod
- Thread starter Zited
- Start date
Idk it was the profile rda and I changed the squonk pin in it to a normal dripper pin and idk what happened like something is stuck in the hole where you put the pin so I can't put the 810 pin In lol I was mad too say the least
D
Deleted member 54254
Guest
Maybe that was the rdta, I forget now...
Ffs it's not working
keeps giving me breaker protection on my ohm reader whatever that means and not firing and when it does sometimes fire the ohms are all over the show.... I wanna cry
I do still have all the bits but by bits I mean literal bits I took it all apart to try and fix it hahhaDunno, never bothered with it as the bloke involved with it was a bit of a gobshite so I passed, maybe @nwhornet might have a few pointers, I seem to recall he quite liked it. Assuming you still have all the bits
nwhornet
Legend
- Joined
- Feb 22, 2016
- Messages
- 12,052
Never used them in non squonk mode & even then only on regulated mods. Mesh gets way too hot for my tastebuds on a mech. The squonk pin should unscrew/screw easy enough. It's just the inner part that comes out, not the whole 510. The screw for the spring maybe tightened down too much as this shares the 510. If it's in bits rebuild the deck first, ceramic block, spring & clamps. Then fit the squonk pin.Dunno, never bothered with it as the bloke involved with it was a bit of a gobshite so I passed, maybe @nwhornet might have a few pointers, I seem to recall he quite liked it. Assuming you still have all the bits
@John R got them all
from OG to the RDTA
D
Deleted member 54254
Guest
got them all
I suspected as much, I was sure you'd mentioned them before. I don't make it a habit to memorise folks kit, LOL
Similar threads
