Connection issues

[scotty7910]

Does it make any difference that's its adna 40 rev 4b?

 

[scotty7910]

With everything in place and the side plate off can you see a gap at either contact,can you push a slither of paper between the contacts.It might be the pin it could have taken a knock and moved.Have a look at the pin above,does it look the same.

Thanks will do rather than a knock I'm wondering if overtighten over time might have done it.

 

[Vapaneezer Scrooge]

Thanks mate,

Don't have a caliper set. How ever I don't reckon it's really protruding at all. So if I used the sealing of the pin as reference to access the pin and somehow get it to move up?

If you're really stuck send it to me and I will fix it for free as long as you don't mind covering the postage, if it's a connection problem i will get it fixed one way or another.

I feel the o-ring is your easiest and best option, I'm about to seal my new BB so taking it apart, I will measure the diameter and let you know (and possibly source) which o-ring will do the job.

 

[Phat Barstood]

Thanks will do rather than a knock I'm wondering if overtighten over time might have done it.

It could be anything,but there should be no gaps with it all in place and the end cap screwed down.This is an electrical circuit and the top screw is 'earth' or so I believe.Either way the bottom pin must be in contact with the coil or bridge,and the top screw in contact with the tube/chimney,so it makes a circuit.

 

[Vapaneezer Scrooge]

Does it make any difference that's its adna 40 rev 4b?

Not seen a DNA 40 so I can't compare, can you photograph the connection pin with the tank out and also the button side without the panel?

Is it an original or SXK?

 

[rew]

Not seen a DNA 40 so I can't compare, can you photograph the connection pin with the tank out and also the button side without the panel?

Is it an original or SXK?

I did have an SXK DNA 40. Mine was a BB 4a. It was exactly the same as DNA 60 apart from the chip/ board

 

[Rob]

@scotty7910 is this the one I sent over? @domejunky

 

[zouzounaki]

@scotty7910 is there any movement at all in the boro tank when you have it screwed in? Also, are you holding the tank in while screwing the top screw on? I find I need to push the tank in with my thumb while screwing to make sure it’s seated right and has a good connection.

 

[scotty7910]

Not seen a DNA 40 so I can't compare, can you photograph the connection pin with the tank out and also the button side without the panel?

Is it an original or SXK?

Will do cheers its an original.

@scotty7910 is this the one I sent over? @domejunky

No @Rob that one is working fine.

@scotty7910 is there any movement at all in the boro tank when you have it screwed in? Also, are you holding the tank in while screwing the top screw on? I find I need to push the tank in with my thumb while screwing to make sure it’s seated right and has a good connection.

No movement at all everything seated correctly as far as I can tell. Have used hybrid tips etc too and no change

 

[joe clay]

@scotty7910
@domejunky is your man...or feel free to send it me and i will try sort it for you...just post to me and you pay postage back to yourself.