Custom squonk mod...FINISHED!

[joe clay]

Well today i managed to put a few coats of a special liquid on the mod after i sanded it, then when dried, sanded again, then more liquid, then sanded again and liquid again, then finally sanded it back a little then the 1st stage of polishing, which is where i'm at now after the 1st polish.....lots more to come...

 

[tootingyoda]

Outfekinstandin sir.

 

[Maniac]

This mod will be glossier and shinier.....i feckin hope so

What will be used to clean and polish the resin? Sandpaper of some sort or some chemicals?

 

[joe clay]

What will be used to clean and polish the resin? Sandpaper of some sort or some chemicals?

Both [emoji6]

 

[joe clay]

Well lot of polishing today, and fitted the bf 510, the fire button and internals.... polished the top and bottom and the door, to near where i want it to be, then had to give a fine sanding to the battery door so I could do some art on it, i know its rough at moment but it will be straightened out and then every where on the door thats in black pen will be engraved at a good depth and the oval bit will be cut out, and after engraving am hoping to fill it in, in blue resin and then some greyish/blueish shading as i want it to look like a vortex hole
.....
....more to come....

 

[Bazz_74]

Looking good @joe clay , any chance of a pic of the internals next time you have the camera out? Is this a straight up mech or are you using a mosfet?

 

[paul-7]

OMG !!! awesome dude

 

[joe clay]

Battery door roughly engraved and 2x holes drilled out so i can grind away for bottle squeeze, then bit more engraving then to infilled with blue......more to come..

 

[joe clay]

Looking good @joe clay , any chance of a pic of the internals next time you have the camera out? Is this a straight up mech or are you using a mosfet?

Using mosfet bud, will take photo next time, but you wont see much

 

[joe clay]

Hole for bottle squeezing cut out and more envraving to make sure its deep enough for resin infill