Fogger by Yi Loong

[KulrMeStoopid]

Just a heads up peoples...this is more advice versus a warning.


When you get your fogger, flip it over, unscrew the centre pin inside the threading. Check it for an o-ring. There may be one, but it will be squished further down. Go into your spares pack..get the smallest o-ring out, pop that in there and put the centre pin back in.


I learned the hard way last night and thanks to @ dan

I nearly shorted out last night and created A LOT of heat!

 

[MadTz]

am sure todd also mentioned this in his review of it and that's why i changed my mind about getting one

 

[KulrMeStoopid]

am sure todd also mentioned this in his review of it and that's why i changed my mind about getting one

Well not everyone watches Todd's reviews do they?

~×XOo~sent with love from the Nerm~oOX×~

 

[ScottChensoda]

The word I have is that the central rubber grommet has been removed as it had a habit of melting (might want to keep an eye on that KMS) and the short has been fixed. Which time will no doubt tell.

 

[KulrMeStoopid]

Its surely not fixed in mine

~×XOo~sent with love from the Nerm~oOX×~

 

[Vape Geek]

Its surely not fixed in mine

~×XOo~sent with love from the Nerm~oOX×~

So thats why my little bugger is heating like it will blow some hot magma any moment!
thanks for advise KMS
x

 

[ScottChensoda]

So are you returning that batch you just bought Nat?

 

[whit77]

http://www.youtube.com/watch?v=ioRIQr4VGOI

 

[Gilliandrea]

Been vaping on the Fogger for the last hour and no problems at all!! Loving the vape this gives

2 strands 1.5 ecowool with silica core and 4 wraps 0.2 kanthal, extra o-ring in 510 connector, left in the o-ring at the wick = 1.8ohm
Not as warm as the KFL but lovely all the same, well worth the wait

 

[ScottChensoda]

Good enough for me. Sold to the gentleman in the red shirt.