GTX 0.15o coil question

[Daniel Ismay]

Hello, I have a question following my purchase of GTX 0.15o coils.

I bought a bunch of GTX 0.15o coils because I wanted to start vaping at 70w, my vape itself allows up to 80w but when I put the new coil in, it tells me the best wattage to vape at is 45-60w, despite the packaging the vapes came in telling me to vape at 60-75w. I am now left confused. Is my vape wrong about the wattage I should vape at? Should I ignore it and vape at 70w or follow what it says on my vape? Any help would be much appreciated on this subject. Also, is there any negative impact at vaping below recommended wattage, aside from Flavour? Thank you.

 

[gary68]

Vaporesso say 70 Watts... But I never go by the manufacturers recommendations. Start at the low end and increase until your happy.

 

[gary68]

@Daniel Ismay check that you actually have 0.15 ohm coils not 0.20

 

[MrDJ]

If your using a 80watt mod I guess it's the pm80. This mod will be pointless to vape at the almost max wattage and it will most prob only last for 20-30 mins before battery is flat. I use the 0.15 at 30 watts and it's plenty as way to hot for me otherwise.
As said, just cos it says it will go up to that wattage it's never a good idea to max it out. If you want to vape at 70 with mahosive clouds then you need a 200+watt mod and use a real subtank like free max mesh pro or similar.

 

[Crispycritters]

I think you would be best by starting at the wattage recommended by the mod and slowly turn up the power ab 2 or 3 watts at a time until you find the sweet spot that suits you. If it starts to seem 'dry' then you've gone too high, so back off a little or you'll burn the cotton and trash the coil. As long as you stay at, or under the max recommended wattage you'll be ok.

There is no problem vaping under the recommended minimum range if you like the vape, but if you go too low the coil may flood and get gurgly because it isn't heating up enough to vaporise the juice.

Personally I think vaping at 70 Watts on a single battery mod is pushing it. If you want to vaper that high you'd be better off going for a dual battery mod, unless you're happy to carry a few spare batteries with you.

 

[gary68]

If your using a 80watt mod I guess it's the pm80. This mod will be pointless to vape at the almost max wattage and it will most prob only last for 20-30 mins before battery is flat. I use the 0.15 at 30 watts and it's plenty as way to hot for me otherwise.
As said, just cos it says it will go up to that wattage it's never a good idea to max it out. If you want to vape at 70 with mahosive clouds then you need a 200+watt mod and use a real subtank like free max mesh pro or similar.

I'm using a 0.15 and find 30 ish plenty of power. The rating manufacturers give are fucking ridiculous