What's new

How do you deal with Gurgling???

With my iclear 30b I just take it off the mod turn it upside down and blow threw the 510 connector whilst holding abit off tissue where the mouthpiece goes,screw it back on to your mod amd your all good to go.(little trick I saw I youtube)
When you blow threw any excess will come out the mouthpiece.
Keep your tank topped up also as that helps

Sent from my SM-N9005 using Planet of the Vapes mobile app
 
Last edited:
I did that but just fluid came out the bottom of the tank,where if you turn it upside the the coil is out of the juice so when you blow it clears it out and doesn't drag more into it.
Thats how I have always cleared mine without taking it apart without any issue's

Sent from my SM-N9005 using Planet of the Vapes mobile app
 
It might be blow threw the top for top fed coils???

Sent from my SM-N9005 using Planet of the Vapes mobile app
 
I've tried everything for gurgling, nothing has worked.....

I must admit that trick has only worked on the iclear 30b,my tank off the emode I had flooded all the time no matter what I tried

Sent from my SM-N9005 using Planet of the Vapes mobile app
 
Aaron1988 I think you supposed to do it the opposite way ie. blow through mouthpiece out of connector end.

If you do that it will pull liquid through the wicks due to the pressure caused by blowing, and you'll blow out even more juice!

Sorry thought you meant blow through the mouthpiece :imstupid spent too long on the xbox and my eyes have gone funny
 
Last edited:
With all my kanger clearos I just give them a flick at the floor (outside if the oh is reading) and this sorts it out for me usually mainly condensation
 
Last edited:
When using a bottom coil clearomizer, fill up before the tank is empty. Gugles when the tank is almost empty.
Holding the cigarette horizontal and drawing gently, uses up the excess liquid and stops the gurgling.
If it is too bad, remove the clearo from the battery, hold a tissue at the bottom and blow into the tip.
 
ok if you are old enough you will remember the old fashion thermometers, well to reset them after taking temp you used to give them a quick flick towards the floor , do this and it should shift the excess liquid then dab the end or shove a bit of tissue up the mouth piece to clear any drips that might be there x
hope that makes sense x
 
Back
Top Bottom