What's new

My First Tin Mod

Gilliandrea

Achiever
Joined
May 17, 2013
Messages
3,169
Not exactly what I planned to do but it works, think I will stick with making wooden mods ;)

What I used:
510 unsealed connector; 18650 battery case; 1oz tobacco tin; 3ml Vivi Nova; On/Off switch; Horn switch and Homemade Drip Tip with extended base

I can change the tank as the drip tip is fixed in place and the 510 connector has been left with 30mm of covered wire :D

Finished1 (623x1024).jpgFinished2 (570x1024).jpgFinished3 (571x1024).jpg
 
good job aslong as it works :) I did like your wooden one tho when i seen it :D
 
Looks very tidy. I was thinking about doing it like that with an Evod inside the tin.
What glue / putty / etc have you used out of interest?
 
I like that a lot!
Can see it being a pain to use in the cold though...
 
That's great! Love the fingernails too! (I always notice obscure things in photo's) :D
 
good job aslong as it works :) I did like your wooden one tho when i seen it :D

Think I prefer the form of the wooden mod too ;)

Looks very tidy. I was thinking about doing it like that with an Evod inside the tin.
What glue / putty / etc have you used out of interest?

None, created the hole so that the drip tip was forced through using clamps and it has o-rings above and below.
Used hot glue to fix the battery case and LED cover in place ;)

I like that a lot!
Can see it being a pain to use in the cold though...

Nope fits in my pocket just fine and I wear gloves when I'm out in cold weather :P:P
 
I never change tanks when I'm out, never thought of that :)
I just take what I need with me... with 2 or 3 backups :D

hahahaha :P
Thinking about it... I always leave the house with two mods, three tanks, and a dripper, and 3 bottles of juice...
Crikey D:
 
Back
Top Bottom