new to dripping, how do i do it 'right'?

[u8myufo]

What is the obvious bit im not doing?

Sucking hard enough! C`mon @Pepper you have had some good advise from others, so somebody had to say it

 

[Miss Pepper]

u8myufo just tried that. More flavour tiny bit more cloud

 

[whit77]

where's the air hole in your dripper, base or top cap? and what ohm coil ?

 

[Phantom Diablo]

for that dripper you only need tny bit of wick too. for cotton wool literally about 1cm length and 1-2mm thick strand at most, and make sure the cotton wool doesnt block the air hole.
i dont have my little dripper built at moment to show you how much will see if i can get it done later and take a pic to show how much cotton. also do you have ohms meter. could be the coil is shorting so your not getting the right ohms. when its dry with no wick or juice the coil should glow red from inside out within a second

 

[Miss Pepper]

Will answer as best as i can hope you guys are ready for entertainment again

The dripper has 4 holes of various sizes and that twists on the main bit that has 1 hole so i can bick big to little air flow. That is on the side.

Taking that off and looking in the dripper it has 3 posts....which appear like ive dropped juice in them ive tried rolled up tissue to dry the posts but think i need something a bit stiffer.

I have a full coiling / wicking kit ohm reader etc at home. Trying best to sort it on the bus

 

[whit77]

line the "open" air hole like above

 

[whit77]

 

[Miss Pepper]

line the "open" air hole like above

That works. Didnt realise the base moved. Just had vape coming out my nose while taking u8myufo advice of sucking harder ouch

Not huge clouds yet, work in progress

 

[whit77]

check what ohm coil you have when you get home, you want 1.8 or below on a mech mod

 

[Miss Pepper]

Dont think you guys are gona like this but the ohm reader is registering 3.13