New user with questions.

[doormatt]

They don't seem to be doing them anymore?
I've been having a look around on other sites but the postage is ridiculous!It's about £3.50 to send a £6 item making it nearly a tenner!
A few sites charge a flat rate of £1 but don't stock EVOD's.


Just ordered an MT3 as they hold a bit more juice and postage was only £2 from Vape escape.It says on another site to wash it out b4 use i take it that means just the tank?

***Please make sure to clean the parts before use! I recommend you take it apart and wash out the tank and the other parts (except the coil head)

Its just to get rid of any dust ect from manufacturer, quick wash and your good to go

 

[bonezee]

Its just to get rid of any dust ect from manufacturer, quick wash and your good to go

But should i ignore the whole of the post/coil part? and just give that part a quick wipeover?
Hope it turns up tomorrow,just had a serious dry hit from my clearomiser eeugh!I can see why people are making bottom coils now.

 

[doormatt]

To be honest its probably fine to just fill up and use but if you want to be safe then just give the part that holds the liquid a quick rinse under the tap then dry it of with some kitchen roll or toilet roll, make sure its dry.
I'm sure when it comes it will be clean, the vendor is just covering there ass, quick wipe down wont do any harm.


Happy vaping

 

[bonezee]

Got my MT3 today and it's so much better than the Redux clearomiser.A really nice smooth vape,but that could be down to the new juice that i got toaday too? Celtic vapours-cherry ice a very smooth vape with a nice cooling menthol.

 

[bonezee]

Gave my Kanger MT3 its first refill but in my haste i didn't prime it and had a dry hit.I persevered with it but i still feel like my juice doesn't quite have the same taste? I have vaped about 1.5ml and it is getting better.
So my questions are,is there any way of getting it back to how it was as it was lovely?
Will it have tainted the juice?can it be saved/put back in bottle with fresh stuff? or would i be better of binning it or just vaping it and switching coils when it's done?
I have a 1.8ohm coil on its way so i will be swapping them out,so i could soak it overnight if need be? I'm thinking that the best way to prime these is to put a drop of juice on the wick replace the post/coil into the freshly filled tank and let it soak upright for a few minutes to make sure there is no air trapped in the coil?
Lesson learned and i'm going to make sure this never happens again.