Oumier Wasp

[Stevie_D]

I've been looking at these as well, I'm looking forward to hearing how good they are, I've got a Goon LP on the way, but something nice single coil flavour chaser will be something I know I'll be using as well.

 

[eyeball kid]

I've been looking at these as well, I'm looking forward to hearing how good they are, I've got a Goon LP on the way, but something nice single coil flavour chaser will be something I know I'll be using as well.

The goon lp is a good rda but must be coiled with care. Keep your coils around 2.5mm and nothing too fancy or it will do your head in shorting every five minutes. I found I preferred the 22mm clone with micro coils.
Don't be put off it just takes a little work to ballance coil vs airflow.

 

[Deleted member 39468]

@eyeball kid @mannikon I see this pop up this morning. Do you think it'll have a Bf pin?

 

[eyeball kid]

@eyeball kid @mannikon I see this pop up this morning. Do you think it'll have a Bf pin?
View attachment 124806

No idea bc. But as I remember the goon takes the standard 2.5mm ft pins.I think I have a few knocking about if doesn't. So either way your covered.

 

[mannikon]

No idea bc. But as I remember the goon takes the standard 2.5mm ft pins.I think I have a few knocking about if doesn't. So either way your covered.

BC, as eyeball said, even if it doesn't come with a bf pin, it will likely be convertible. There are SO MANY Goon clones being sold, hard to say what it comes with and as a new inventory item it won't always have correct or complete description or even pictures although this one doesn't have that "pics provided by manufacturer" so may be WYSIWYG. Six pages of Goon Styled RDA 24mm on FT and then there's RDTA and maybe other variations
The one you list is not shipping for 7 days so keep an eye on it and see if more info comes up.

 

[eyeball kid]

In case any poor bigger stumbles onto this thread we better give it an ending. Well I know those who ordered the brass have disliked the base. My s, steel one is excellent not the most heavyweight bit it's a super cheap rda. Build quality is excellent. Airflow goes from fairly open mtl to restricted dtl. Dead easy to coil. And although it's designed with a pei chuff cap you can fit a 510. Some positions of the airflow do cause the dreaded whistle but my preference of wide open or shut right down where fine. Flavour seems great so far. It's not in the same league as the hadaly but a good single coil squonk rda.

 

[Stevie_D]

I'll look forward to trying it when it gets here, I've got that and the new Maze v3 on a joint order so it may be a couple of weeks before it gets here but I'm looking forward to trying them both out.

 

[adjam1972]

Ok got my wasp today plan on using it in a mech squonker and need some build suggestions.

Whats everyone using ?

 

[stevoknevo]

Ok got my wasp today plan on using it in a mech squonker and need some build suggestions.

Whats everyone using ?

I've got a 24awg Ni80 single parallel, 5 turns around 3mm id coming in at 0.2 - cracking vape in my hadaly on a mech, Oumier should be similar at 0.2/0.3. Parallel or twisted 24awg SS gives a mech friendly coil too.

 

[adjam1972]

Cheers will give them a bash