What's new

Pulse G clone leaks

RicModMaker

Vendor
Joined
Oct 29, 2013
Messages
3,240
Has anyone managed to stop this Atty leaking? Why oh why did they put a hole in the reducer block?
Any tips?

Sent from somewhere in Kent.
www.vapechat.co.uk - Vaping chat room
 
Wrap a bit of kanthal around where the rings go,then pop the rings back on,if this is what you mean.tightens the glass up.
 
Wrap a bit of kanthal around where the rings go,then pop the rings back on,if this is what you mean.tightens the glass up.

I'll give that a try but there's still a hole in the reducer that will let air into the tank buggering up the vacuum. I tried doctoring a bung from an old elites silicon cap but it still leaked.
Maybe I'll squirt some diy sealant down the hole so its a snug fit. What do you reckon?
I only want it to behave and not leak like my RSST.

Sent from somewhere in Kent.
www.vapechat.co.uk - Vaping chat room
 
Are you lying it down or vaping while performing acrobatics in a plane? :D
 
My kraken dosnt have a bung in the filler hole and it dosnt leak i dont know why.I thought ya meant it was leaking around the glass thats why i suggested what i did.i was gonna say one of those little spikey silicone things from a carto but looks like youve tried that.
 
Are you lying it down or vaping while performing acrobatics in a plane? :D

My RSST could handle it. Why not this pulse g. It they gave me some spare short screws, I'd ditch the reducer and shove an RSST bung in the filler hole but the tight buggers haven't.

Sent from somewhere in Kent.
www.vapechat.co.uk - Vaping chat room
 
Ive taken some sand paper to the reduce block and it seems to have done the trick. I'm wondering why there are 2 holes in the top cap though as there are no extra screws provided. I'd dual coil this puppy up if there were so the 2nd air hole is pointless. Any thoughts? Maybe I could get a couple of screws from somewhere but I haven't got a clue what they are and where I'd get them.

Sent from somewhere in Kent.
www.vapechat.co.uk - Vaping chat room
 
Last edited:
Back
Top Bottom