Salts Coils .. Which to use ?

[Deleted member 58360]

One question. What ohm coul do you use ?

Mate, it's honestly not relevant.

The wife uses 0.25 nunchaku and 0.4 rpm coils and switches between 10mg and 4mg salt juice.

I use anything between 0.1ish and 1.6 self made coils, and occasionally 0.4 boost coils, all with 2-5mg freebase juice.


Part of (most of) the obsession with "oooh, you shouldn't sub-ohm salts" is from America - where 50mg salt juice is/was freely available but freebase tended to be much lower strength, like up to 18mg.

50mg anything sub-ohm (using "sub-ohm" as the common colloquialism for DTL) is probably not a fantastic idea for most people

 

[Ash Bibby]

You guys are really helping. I am taking all this information in. Going to become a vape geek with everyone one here

 

[hack400]

1. Stick a coil in (prime, add juice etc.).
2. Set watts fairly low.
3. Try it.
4. Like it. Stop.
5. Too hot. Lower the watts a bit. Go to step 3.
6. Too cold (not enough flavour/vapour production). Up the watts a bit. Go to step 3.

Don't listen to folks telling you you're doing it wrong. If you like it, you're doing it right.

 

[Deleted member 58360]

1. Stick a coil in (prime, add juice etc.).
2. Set watts fairly low.
3. Try it.
4. Like it. Stop.
5. Too hot. Lower the watts a bit. Go to step 3.
6. Too cold (not enough flavour/vapour production). Up the watts a bit. Go to step 3.

Don't listen to folks telling you you're doing it wrong. If you like it, you're doing it right.

You should make a prettily coloured flowchart

 

[Deleted member 54254]

1. Stick a coil in (prime, add juice etc.).
2. Set watts fairly low.
3. Try it.
4. Like it. Stop.
5. Too hot. Lower the watts a bit. Go to step 3.
6. Too cold (not enough flavour/vapour production). Up the watts a bit. Go to step 3.

Don't listen to folks telling you you're doing it wrong. If you like it, you're doing it right.

Does this count as a lifehack?

 

[Cozy]

One question. What ohm coul do you use ?

When I was using my voopoo vinci I think I generally used the VM4's, 0.6ohm coil for my 20mg salts, I think i also tried one 0.8 but preferred the 0.6ones, maybe grab a pack of them and give them a try, see how you get on with them, drink a bit less juice and run at lower wattage too, but like all have said whatever works for you really

 

[Sam Andrews]

1. Stick a coil in (prime, add juice etc.).
2. Set watts fairly low.
3. Try it.
4. Like it. Stop.
5. Too hot. Lower the watts a bit. Go to step 3.
6. Too cold (not enough flavour/vapour production). Up the watts a bit. Go to step 3.

Don't listen to folks telling you you're doing it wrong. If you like it, you're doing it right.

Try explain the last sentence to my wife

 

[Ash Bibby]

Just caught up on these after work.

I tried talking to my wife about it and all I got was the resting bitch face like she didn't give a fuck

 

[Crewella]

Just caught up on these after work.

I tried talking to my wife about it and all I got was the resting bitch face like she didn't give a fuck

Then you're doing it wrong ............

 

[Ash Bibby]

Then you're doing it wrong ............

Any suggestions ?
Apart from getting belt out ?