What's new

The big X

RSJFT

Postman
Joined
Feb 5, 2014
Messages
90
Hey blokes...check it out...took me about three hours to get it right...but it's running a sultry .6 ohms and glowing like Uncle Marsellus' suitcase ...hits like a champ

Rob
JFT




Sent from my PantechP8010 using Planet of the Vapes mobile app
 

Attachments

  • 1393110673661.jpg
    1393110673661.jpg
    49.6 KB · Views: 82
Yay...i can post pics now!

Sent from my PantechP8010 using Planet of the Vapes mobile app
 
So what's going on here then? I see 3 screws and 4 springs. Care to elaborate? :imstupid
 
Decidan it's an igo w ...the center pin is the positive the outer two are the grounds each coil is anchored to the positive (four wires In the center pin) and then to one of the grounds (two wires in each of the outer pins) completing four coils with three pins vaporsizer running IMR 18650 MNKE 1500mAh 3.7 ohms...think thats okay? The shopkeep isn't allowed to endorse anything to be used at subohms by store policy, but said i should be okay MASTERZULU looked better after i fired and pinched...cloud is lovely
Cheers!


Sent from my PantechP8010 using Planet of the Vapes mobile app
 
Last edited:
@Decidan it's an igo w ...the center pin is the positive the outer two are the grounds each coil is anchored to the positive (four wires In the center pin) and then to one of the grounds (two wires in each of the outer pins) completing four coils with three pins @vaporsizer running IMR 18650 MNKE 1500mAh 3.7 ohms...think thats okay? The shopkeep isn't allowed to endorse anything to be used at subohms by store policy, but said i should be okay @MASTERZULU looked better after i fired and pinched...cloud is lovely
Cheers!


Sent from my PantechP8010 using Planet of the Vapes mobile app


Not a bad looking build, needs the tweezers on some of it to tidy it up a bit but if it works it works.
i would be very dubious about using a battery for sub-ohming that you are not sure on the amp rating, personally i only use the Sony VTC4 2100mah batteries that are rated for 30amps continual discharge
 
Good work sir, Im feeling all inspired now :-)

Sent from my HTC One X using Planet of the Vapes mobile app
 
Good job,well done.This is my W3 from a first building session(is actually about my 10th try in that session)

IMG_0609.jpg
 
Back
Top Bottom