Vapor in my tank...

[mrHAIRYface]

Right guys I've found a wick setup that works for me, on my AGA T2 I have a 0.7ohm normal coil, enlarged the airhole as it was like sucking a potato through a straw, got a thin mesh wick with cotton wool wrapped around the top as ekowool just doesn't do it for me, hate the taste, works like a charm, using it more over my fogger now, never thought that would happen.



But I get vapour in my tank and the vapour I get off of it is good, a little more for a 0.7ohm coil would be nice.



Air can go down the side of the wick so would I gain a little more vapour by blocking those two extra holes off? I wanna get this right as was put off by the kraken as I couldn't get it to vape at all well for me, but I'm slowly getting the hang of this genny lark so would love for it too work

 

[KulrMeStoopid]

vape in the tank is normal, its basically pressure, your sucking the heated liquid out and the lowering level of the unvaped e-liquid pulls a lil vaper in.

You can block off the holes if you want, but you might create a vapor lock which will prevent the e-liquid from rising up the wick.

 

[mrHAIRYface]

That's alrite then, might try blocking one off see how that goes but if not, I'm not too fussed, flavour is wicked

 

[clint]

My aga t2 does the same, its fine. I find that if you plug the fill hole it causes dry hits so I just leave it open and it never leaks.
I've enlarged the wick hole on mine and I can use 2mm voodoowool as a wick and it works brilliantly.
My aga t2 is used daily again, I've been well impressed with it lately.

 

[mrHAIRYface]

I've got my second wick hole open and semi plugged the fill hole with a oring really shoddily but notice a little difference