the_atomic_fart
Achiever
- Joined
- Nov 15, 2015
- Messages
- 3,209
OK, as much as I like this tank I seem to have a frustrating problem with it;
After a period of use, a couple of tanks say, a gap starts to appear around the airflow ring.
I have to take it off the mod and give it a few persuasive taps on a firm surface to get it flush again. I've tried to adjust the positive pin to pull it flush but this doesn't work.
My main concern is that I almost exclusively use this on my Nemesis, as the gap appears the positive pin is pulled up through the connector a similar distance.
Makes me a little concerned about using it on a mech.
Read on another forum about one or two others having similar problems, that's where I found the 'give it a whack' fix!
Anything similar from any Apes here? Perhaps a more permanent fix?
Cheers.
After a period of use, a couple of tanks say, a gap starts to appear around the airflow ring.
I have to take it off the mod and give it a few persuasive taps on a firm surface to get it flush again. I've tried to adjust the positive pin to pull it flush but this doesn't work.
My main concern is that I almost exclusively use this on my Nemesis, as the gap appears the positive pin is pulled up through the connector a similar distance.
Makes me a little concerned about using it on a mech.
Read on another forum about one or two others having similar problems, that's where I found the 'give it a whack' fix!
Anything similar from any Apes here? Perhaps a more permanent fix?
Cheers.