G60
Postman
- Joined
- Apr 1, 2014
- Messages
- 347
I'm finding it all a little daunting at the mo, possibly because the coil is the only variable so I can't change anything once the coil is in.
I've only got 28g kathal at the mo, and both builds have come out at 1.35 and 1.41 ohms....even tho I was aiming for 1.6ish so more experimenting to do I think! I think with adjusting for the coil legs being opposite I must have done one wrap less than I needed.
The hardest part for me is getting the coil legs to stay under the screws. So ruddy fiddly to get them in place and then nice and tight. I'm sure I'll get the hang of it tho.
Sent from my iPhone using Planet of the Vapes
I think 1.3-1.4 on a mech with a Kayfun should be ok and you should be fine with the wire that you are using although personally I use 0.28 or 0.3. I find that you want about 1mm between the air hole and coil. That wire you are using is quite thick so you do have to remember it won't vape like an Evod straight off the bat because it takes a second or so to get the coil up to temp.