Anybody rebuilt a Crown 3 coil yet?

[Pilgrim Wire]

Wotcha gang. As above, has anybody tried rebuilding a Crown 3 coil yet? Just pulled one apart and I reckon it can be done quite easily. Going to have a bash in the morning. Only obvious problem I can see is the wicking material on the juice inlets seems to be built into the housing. Might not be able to replace that. Hmmm. Anyway, if anybody's done it let us know how you got on. I don't normally use stock sub ohm tanks anymore for various reasons but this little monkey is none too shabby. I'm just too tight to buy coils. And I fancy putting some silly things in it. Cheers my friends!

 

[peafrog]

Hey Pilgrim23, did you manage to give it a go? Thinking of buying this tank but don't want to until I know I can rebuild the coils! (I am also cheap haha)

TIA

 

[Pilgrim Wire]

Hello mate. To be honest with you I’d forgotten all about it [emoji23]. Haven’t really been using tanks at all for ages. If I do have a bash I’ll post up any results, good or bad. It’s a good stock coil tank though so if you can get one cheap somewhere by all means fill ya boots!

 

[peafrog]

Haha oh well! If I'd done a few others I might give it a go but I literally can't find ANYONE rebuilding these! Crazy! I've found the tank for very cheap but not having any chance to rebuild the coils and having to buy them from the US to get the coils cheap enough is looking like a bit of a nightmare :/ I'm replacing my current (slightly dodgy) tank so it would be my only tank! Hmmmmm....

 

[Pilgrim Wire]

Just buy an RTA and have done with it mate [emoji6][emoji23]