Bishop v1 issue: Black vs. SS

[MTB Vaper]

If I get any flooding/gurgl5 with BPMODS cotton I use Muji instead that seems to solve it in my limited experience. I save the BPMODS for RDA's now.

 

[Deadanddripping]

I only have a black bishop and it's in my hand right now. 6 wrap round wire 2.5mm id and BP mods 2.5mm cotton. Never had an issue. I'd put the black deck in the stainless set up and see what happens. Then work your way through.

 

[Netvaper]

If I get any flooding/gurgl5 with BPMODS cotton I use Muji instead that seems to solve it in my limited experience. I save the BPMODS for RDA's now.

I'm currently using BP Mods cotton in it with no issues, didn't with muji or slivr either.

 

[MTB Vaper]

I'm currently using BP Mods cotton in it with no issues, didn't with muji or slivr either.

That's good, I've only got a Tauren V1.5 and a few Ares MTL RTA's. Had slow flooding with both using BPMODS pre sized cotton, no slow flooding issues using Muji pads, can only assume it does a better job at damming up the juice slots.
Also got a Mechlyfe Fallout MTL zero issues with BPMODS since day one.

I'm not criticising the cotton, just offering my experience on the same issue to help.

 

[Deadanddripping]

That's good, I've only got a Tauren V1.5 and a few Ares MTL RTA's. Had slow flooding with both using BPMODS pre sized cotton, no slow flooding issues using Muji pads, can only assume it does a better job at damming up the juice slots.
Also got a Mechlyfe Fallout MTL zero issues with BPMODS since day one.

I'm not criticising the cotton, just offering my experience on the same issue to help.

Bp cotton feels more slippery and seems to take a little while to bed in flavour wise. I think the rougher fluffier muji holds liquid a little better. Either way, both work.

 

[omroth]

Silly question - does the Bishop also have an AFC ring which has been pushed too far?

Apart from that my guess would be o-rings.

 

[Netvaper]

Silly question - does the Bishop also have an AFC ring which has been pushed too far?

No afc, just 2 side air pins.

 

[illuminated vaper]

So, I've tried putting the SS' tank on the black deck and the result was a much better draw and most of issues solved, but not fully. I've changed the o-rings on the black deck and the black deck now, with the SS tank is as good as the SS atomizer.

Next, I'll change the o-rings on the black air pins, although, I have only two spare in the box, but I'll change the inner ones on both pins. That should probably solve the issue (hopefully), but I'll update here. Thanks a lot, everyone!

 

[LordOdin]

Buzzng would suggest a power issue, maybe a short somewhere, check your Coil Legs and also check for thin strands of wire that could have been left from a previous build.

 

[illuminated vaper]

Buzzing was coming from the air intake... It's heard on one of them and for around half a second of the beginning of the draw (it didn't used to be every single time, but, maybe every third on average). It "seems" like the air tube isn't clear, but it is: I've been taking the air-pins out, "air blow" it for a while, put back, and I'd hear it again on the first draw.

Since I've changed the o-rings on the deck the buzzing happened only once, or twice, very first few draws and for a tenth of a second, but not a single one since then (I'm half tank through at the moment and I'll be re-wicking now again).