First RDA setup?

[Clouded]

Get yourself a Doge v3 here

https://www.ecigwizard.com/doge-v3.html

£7.99 for an authentic and it's not a bad dripper at all.

2.5 or 3 mm coiling jig from coilmaster or the likes, some snips, kanthal 24 awg wire and cotton and practice away mucker.

Later maybe get a Ohms reader to check your builds.

Good luck

Gaz

Cheers Gaz, I can read the ohms on my 80w mod also right?

Think I'm gonna just get a coil master set with everything in there.

 

[gazlynn]

Yes m8, I used my mod for the first few months to read the ohms. I now just build on the ohms reader more due to ease and habit than anything else.

The coilmaster set is a good idea.

PM me you address and I'll send you some different wires for you to practice and get going with m8.

cheers

Gaz

 

[Clouded]

Yes m8, I used my mod for the first few months to read the ohms. I now just build on the ohms reader more due to ease and habit than anything else.

The coilmaster set is a good idea.

PM me you address and I'll send you some different wires for you to practice and get going with m8.

cheers

Gaz

Awesome! Going to get a doge v3 RDA now.

You don't have to do that man, aleast let me give you something for the postage!

I'll PM you now thank you very much again

 

[Screwball]

I only started building this week, I bought a the doge v3 and a unity dripper, I've had a few goes at building the doge and they're looking better and better each time. I've been using 26awg kanthal 8 wraps on a 2.5mm drill bit dual coil coming out at about .5ohm running on my ipower at 50w. It gives good clouds and flavour. After a few more builds I might look at different wires and setups, but for now I'll keep practicing on the basics

 

[Clouded]

I only started building this week, I bought a the doge v3 and a unity dripper, I've had a few goes at building the doge and they're looking better and better each time. I've been using 26awg kanthal 8 wraps on a 2.5mm drill bit dual coil coming out at about .5ohm running on my ipower at 50w. It gives good clouds and flavour. After a few more builds I might look at different wires and setups, but for now I'll keep practicing on the basics

Just ordered a doge v3, cotton bacon and some wire, looking forward to it!

Practice makes perfect mate, it was all a massive blur to me a few weeks back but after a lot of research and learning with YouTube videos I'm ready to give it a shot.

 

[tobywonkanobi]

Good going @Clouded, if you've watched a couple of tutorials you'll be fine. Just take your time, and let us all know how you get on. [emoji106]

 

[Clouded]

Good going @Clouded, if you've watched a couple of tutorials you'll be fine. Just take your time, and let us all know how you get on. [emoji106]

Cheers mate, will do

 

[Screwball]

Don't forget to post some pics of your builds, look forward to seeing other people's 1st trys

 

[Clouded]

Don't forget to post some pics of your builds, look forward to seeing other people's 1st trys

Of course and plus it will be something I can look back on and laugh about when I get more experienced at it haha!

 

[Ricky 2410]

Of course and plus it will be something I can look back on and laugh about when I get more experienced at it haha!

My first go I could not fit the cap back over as coils was 2 big.