BaDaBooM
Mod Maker
- Joined
- Nov 15, 2013
- Messages
- 650
So lets put a DNA40 in a Cana with led firing button.
Parts list:
Fat Daddy 510
Battery holder 18650
Tactile switches
USB charger
DNA40 chip (Hopefully one with a working screen, check the dna40 spec sheet first batch of boards had faulty screens)
Wire (Check the dna40 spec sheet for what wires to use)
Led 12mm firing button
2mm plastic sheet to make a chip holder out of.
9mm drill bit
12mm drill bit
m10x1mm tap
Resistor
Parts and stuff
Drill and tap the 510 hole, 9mm drill bit and a m10x1mm tap. Don't know how to drill and tap? youtube it
Next drill the firing button hole. I center mine and move it 0.4mm down towards the tactile buttons, this will give the fat daddy a little extra room.
510: This just some different ways of doing the 510. Silver is just drilled and tapped. Green one has been machined so the nut can be used, I like the nut way the best but it only works with a magnetic door.
Led firing button: You have to make a notch for the firing switch nut, as seen on the silver one.
I open the the wire slots between the chip compartment and the battery compartment for thicker wires. Remember to round the edges of so they are not sharp.