im gona join you lot!

[Miss Pepper]

This is funny lol.
Go for it @Miss Pepper , im jealous m8, want to join the "Gang" aswell!
Miles ahead o me! Good teachers you got tho.

Join us then

Im sitting here twisting about 6 inches of wire, remembering when I was coiling the kraken, thinking have I really learnt enough to pull this off

 

[Miss Pepper]

The driller messaged this

 

[Reevo]

Join us then

Im sitting here twisting about 6 inches of wire, remembering when I was coiling the kraken, thinking have I really learnt enough to pull this off

Don't wanna thread jack. Im watching n learning tho lol

 

[Diche]

Well I am off to the pub before it starts raining again, but I am going to do a bit of research this weekend I think and see what I can come up with. It might be fun to see what I can do based on what I have in the house. I doubt it will be spectacular, but it will be a learning experience for sure

 

[Miss Pepper]

Don't wanna thread jack. Im watching n learning tho lol

Do it!
Come on you must know me well enough to know my threads are free for alls

 

[StuPot]

So then, shall we say a minimum of 0.14 ohms for the single coil comp? So 0.14 and above to give you newbies a chance? Miss Pepper Diche VeeDubZ

What about vg / pg ratio? Pure vg allowed?

 

[Diche]

See if you can fit a Parralel twist through post holes

Based on my limited reading and overhearing, would that be 2 coils made from twisted wire mounted one above the other on a single set of posts with all four legs going through the two post holes? Or have I got the wrong end of the stick completely?

 

[Miss Pepper]

Just looking at parallels....

My other one snapped in half.

Attempt two

 

[Miss Pepper]

What about vg / pg ratio? Pure vg allowed?

Yup

 

[Chrisvincent]

say what

One wire straight through